Thanks for visiting Coin Silver. Remember to bookmark this page Silver Half Mark.
Silver Half Mark
Stephen King's Silver Bullet (9/11)
A Few Things Couples Should Know When Choosing Their Rings
For most of recorded history, betrothal and marriage have been represented by the wearing of rings. The earliest ones were not precious metal but were usually made of iron. Some betrothal rings were not even of that quality, being made instead of woven grass. Fortunately, engagements were usually quite brief, so they lasted until the marriage, when they were usually replaced with a metal one. Eventually, silver and gold became more commonly used, and the use of gemstones then followed. However, diamonds were almost never included, since they were scarce and extremely expensive, reserved mainly for royalty. Major diamond deposits were found during the 1800s, which increased the supply and lowered the cost, although both were tightly controlled by the mine operators.
Antique engagement rings often reflect the scarcity and expense of diamonds. Other gemstones were frequently used, such as rubies, sapphires, and amethysts. The settings could be quite ornate, and intricate, delicate filigree was also used frequently. A ring can be as little as fifty years old and still qualify as an antique, or it may be several centuries old. Naturally, styles in both mountings and gems has varied a great deal over time. Therefore, there is really no typical antique ring.
Many brides consider the diamond cut as a major factor in the selection. Most of the traditional cuts have flat tops. The current overwhelming favorite is the round cut. These are often found in solitaires. The faceted sides add to the brilliance of even smaller stones as they reflect the light better. Princess cut engagement rings have a square shape which can be mounted flush with the metal bound. However, this style is frequently used for a solitaire as well, with the mounting prongs placed to cover the corners.
If the rings do not match, the mountings can scratch or catch on each other. You can avoid this by checking the rings together for fit or by purchasing them as a set. Designers make sure they will fit well, and also offer such designs as interlocking rings.
Over the course of the marriage, some couples opt to replace the engagement or wedding ring, or both, with an eternity ring. These bands have gems that are normally channel set into the metal. The stones usually encircle the band completely, but some styles have them only on part of the ring. While diamonds are used most often, they sometimes are combined with other stones, frequently birthstones for the family. Most often, this style of ring is used to celebrate a milestone, such as a silver anniversary. They can also be used as an addition to the other two rings if all styles are suitable.
Most women wear their rings around the clock, so it is necessary to make sure they fit properly. Sizing metal bands is an easy task for a jeweler, and is usually free when you purchase the rings. If you plan to use heirloom rings you have inherited, it is still not an expensive service to have done. However, rings with gems set completely around the metal, like eternity styles, are not normally sized. That would require removing at least one stone, which could detract from the appearance of the ring.
When shopping for an engagement ring, consider whether you plan to wear it all the time or only for special occasions. A large, elaborate ring can prove troublesome when performing normal activities during the day. Having to remove it many times daily can not only be annoying, but could lead to loss. A less ornate mounting may be preferable for a ring that will seldom be removed.
If you are looking for a different item here are a list of related products on Coin Silver, please check out the following:

Frequently Asked Questions...
Is silver marked 925MEX expensive or cheap? I want to know if I got a good deal or ripped off. I bought a?
bracelet 20 cm long and a half a centimeter thick and i wonder how much it's worth or how much I should I have paid for it.
Answer:
925 is considered high grade pure sterling silver, and Mexico is world renowned for having some of the best silver in the world, especially the stuff that comes from the Taxco region, so if it is an authintic Mexican silver piece it should be good.
Right now unworked silver is worth about 18 bucks an ounce so how much it's worth depends on how much it weighs as well as how much work and artistry went into making it.




















































































